How to make a Redstone Repeater in Minecraft (2024)

FAQs

How to make a Redstone Repeater in Minecraft? ›

Add Items to make a Redstone Repeater

With your stone, Redstone torches, and Redstone dust completed and found, you are ready to craft a Redstone repeater. To craft a Redstone repeater, Place your stone across the three spaces at the bottom, the Redstone torches above the stone at the left and right space, and finally the Redstone dust between the torches.

1. To craft a Redstone repeater in Minecraft, you first need to place three stone blocks in the middle row of the crafting area. 2. Then, you need to put Redstone dust in the middle cell of the first row with Redstone torches on either side.

The comparator was added to Minecraft in version 1.5, alongside hoppers, nether bricks and cobwebs. To make one, you'll need three stone, three redstone torches and a Nether quartz – meaning that you won't be making one until you've ventured into the Nether at least once. Made one?

Crafting a redstone repeater in Minecraft requires you to have x2 Redstone Torches, x1 Redstone Dust, and x3 Stone Blocks. The last material is obtained by smelting cobblestone in a furnace or using silk touch on a pickaxe.

Signal delay

Each use increases the repeater's delay by one redstone tick, to a maximum of four redstone ticks, then back to one redstone tick. Longer delays can be made with multiple repeaters – for example, a repeater set to 'four' and another to 'one' provides a half-second delay (0.4s + 0.1s = 0.5s).

There are 20 game ticks per second. Redstone ticks, on the other hand are twice as long. There are 10 redstone ticks per second. So, you would need 3 repeaters; 2 on full delay (8 redstone ticks) and 1 set halfway (2 redstone ticks).

Pistons can push most blocks, and sticky pistons can pull most blocks, except those listed in the table below. A sticky piston simply leaves a block behind if it cannot pull it. Pistons cannot push blocks into the void or beyond the top of the map. They also cannot push more than 12 blocks.

Or you can just put 2 repeaters side by side facing opposite directions, put redstone on either side and send in a 1 tick pusle to start it. Or you can just put 2 repeaters side by side facing opposite directions, put redstone on either side and send in a 1 tick pusle to start it.

You'll need some glass, some nether quartz and some wood slabs. Put them in a crafting grid in three layers in that order, and you'll get your detector. Once you've got it, you can plop it down on the ground and it'll immediately start emitting a redstone pulse based on the brightness of the sky.

Can you craft a redstone repeater? ›

In the crafting menu, you should see a crafting area that is made up of a 3x3 crafting grid. To make a redstone repeater, place 3 stones, 2 redstone torches, and 1 redstone dust in the 3x3 crafting grid.

The lever either needs to be connected by Redstone dust to what it's activating or near what it's activating.

Redstone signals can be transmitted from one place to another with redstone wire – a line of redstone dust. Redstone wire can transmit a signal only 15 blocks – after that it needs a repeater to boost the signal back up to full strength.

A redstone repeater can be "locked" by another powered redstone repeater facing its side. When locked, the repeater does not change its output (whether powered or unpowered), no matter what the input does. When the side repeater turns back off, the repeater returns to its normal behavior.